Cessation of calculation

When I simulated DEM-SPH problem, i.e., a sphere slid along a rugged surface and fell into the water. I set the parameter "TimeMax" value="2.8" and the parameter key="TimeOut" value="0.1" . But the calculation was always stopped at Part_0014 and didn't continue to calculate downwards , i.e., the sphere was still at the surface when it just contacted with the rugged surface.


[Initialising simulation (v43hf1jn) 09-07-2018 18:24:12]
PART PartTime TotalSteps Steps Time/Sec Finish time
========= ============ ============ ======= ========= ===================
Progress 2.28% in 31.0s. Estimated finish time: 09-07-2018 18:46:47
Part_0001 0.102343 43 43 482.44 09-07-2018 18:46:42
Part_0002 0.201734 85 42 484.99 09-07-2018 18:46:46
Part_0003 0.302220 128 43 491.26 09-07-2018 18:46:53
Part_0004 0.401821 171 43 495.62 09-07-2018 18:46:59
Part_0005 0.500740 214 43 498.98 09-07-2018 18:47:06
Part_0006 0.601382 258 44 501.71 09-07-2018 18:47:10
Part_0007 0.701526 302 44 504.36 09-07-2018 18:47:15
Part_0008 0.801239 346 44 506.53 09-07-2018 18:47:19
Part_0009 0.900568 390 44 508.35 09-07-2018 18:47:24
Part_0010 1.001797 435 45 510.03 09-07-2018 18:47:27
Part_0011 1.100460 479 44 511.89 09-07-2018 18:47:31
Part_0012 1.201066 524 45 513.34 09-07-2018 18:47:33
Part_0013 1.301394 569 45 514.73 09-07-2018 18:47:37
Part_0014 1.401464 614 45 516.11 09-07-2018 18:47:40

Comments

  • please send to us the XML file and the Run.out and we will check it
Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!